Touchmill Products

A line of products designed to ennoble the aesthetic and physical qualities of leathers. Treatment is carried out in dry milling drums, to get the most out of every product in a controlled environment.

Curiosity Scarica il pdf


TOUCHMILL NO SMELL

Touchmill No Smell is a formulation that acts on the cause of bad odours. It does not alter the hand of the leather. Touchmill No Smell needs a few days to complete its “odour-eating” process.

Method of use

Touchmill No Smell is injected into the dry-milling drums at a temperature of 30°C - 32°C and humidity of 45%.
Touchmill No Smell must be diluted 1 x 1 part water, 120 minutes before the end of the tumbling phase.
On bovine leathers,3% is used on the dry weight of the leathers. The quantity depends on the intensity of the leather odour.
Once the injection is finished, close the humidistat for 5 minutes, then mill for 90 minutes always at 30°C - 32°C and at a humidity of 45%, then check, cool and remove leathers.
Touchmill No Smell can also be applied by spraying or roller coating machine.
It is also a product to be used in the final retanning bath, before unloading the leathers, in the amount of 1% on the shaved weight.

TOUCHMILL SC04

Touchmill SC04 is an excellent product to fix the powder and colour on suede leathers. It leaves a talc hand, slightly waxy, without being oily. An excellent reviver.

Method of use

Touchmill SC04 is injected into the dry-milling drums at a temperature of 30°C - 32.
Put the product diluted 1 x 3 parts cold water, 2 hours before the end of the tumbling phase.
It is recommended to use 2% on the dry weight of bovine leathers.
Once the injection is finished, close the humidistat and leave it closed for 5 minutes after the product has finished.
After 5 minutes, bring the temperature of the drum back to 45°C and to the desired humidity.
Keep milling for 90 minutes.
Check, cool and remove leathers.
It can be directly sprayed, diluted 1 x 2 parts water.

TOUCHMILL C/A

Touchmill C/A has been developed in order to eliminate the formation of electrostatic charges during the dry milling process. It is very good to avoid dust to stick on leathers. It can be used both on crust and finished leathers and does not change the final touch.

Method of use

On bovine leathers 0,5% of Touchmill C/A based on the dry weight.
It is injected in the milling drum diluted 1 x 6 parts cold water.
It can be injected about 45 minutes after the milling process has started, when the temperature has reached 45°C and the humidity is at least 45%.
Once the injection is finished, close the humidistat and leave it closed for 5 minutes, then bring the drum back to the desired temperature and humidity.
Keep milling as much as required.
Check, cool and remove leathers.